breaking tenacity
英 [ˈbreɪkɪŋ təˈnæsəti]
美 [ˈbreɪkɪŋ təˈnæsəti]
断裂强度；扯断力；抗断韧度；断裂韧性
双语例句
- Effect degree of regain, relative humidity and test number on breaking tenacity of saw ginned cotton and roller ginned cotton were analyzed respectively through orthogonal test.
通过正交试验分析了回潮率、相对湿度和测试次数三个因素分别对锯齿棉和皮辊棉断裂比强度的影响程度。 - Used for testing breaking tenacity, elongation at break of single yarn made of cotton, wool, jute, core-spun yarn etc, at the time including synthetic fiber filament, textured yarns.
用于测定棉、毛、麻、包芯纱的单根纱线及合成纤维长丝，变形丝的断裂强力和断裂伸长率。 - Used for testing breaking tenacity and elongation at break of raw silk in skein and bobbin.
用于测定绞装和筒装生丝的断裂强度及断裂伸长率。 - Effect factors of cotton fiber breaking tenacity tested by HVI were discussed.
探讨HVI测试棉纤维断裂比强度的影响因素。 - Used for testing indexes of polyurethane monofilament, such as breaking tenacity, elongation at break, load at specified elongation, relaxation of stress, plastic deformation, etc.
用于测定氨纶丝断裂强度、裂伸长率、伸长负荷、力松驰、性变形等性能指标。 - The results indicated that PTT/ wool blended fabrics owned the high elongation rate, low breaking tenacity and low tensile module at the high elongation rate by comparing with PET/ wool blended fabrics.
结果表明：与PET/毛混纺织物相比，PTT/毛混纺织物具有较高的伸长率和较低的断裂强度，且能在较高伸长率下保持较低的拉伸模量； - Research on the Breaking Tenacity of Solid Rocket of Different Storage
不同贮存期固体火箭发动机装药或药柱断裂韧性试验研究 - Used for testing indexes of single fiber, such as breaking tenacity, elongation at break, load at specified elongation, elongation at specified load, creep, etc.
用于测定各种单根纤维的断裂强力、断裂伸长率、定伸长负荷、定负荷伸长、蠕变等性能指标。 - Finite Element Analysis on Testing Dynamic Fracture Toughness of Rock breaking tenacity
岩石类材料动态断裂韧性测试的有限元分析 - In gray yarn and unraveled weft yarn from fabric, yarn properties such as breaking force, tenacity, elongation and breaking work are studied with weft breaks of coarse, medium and fine count yarns.
研究了原纱和织物上拆解下来的高中低支纬纱的诸如断裂强力、强度、伸长和断裂功等性能。 - The results showed that the retention ratio of breaking strength of high tenacity PP filament with 2% antiaging masterbatch was 80.2%, and those of breaking elongation is 79.0% by 1 year in outdoor exposure.
结果表明：添加2%的防老化母粒，经1年的户外大气暴露试验，聚丙烯高强丝的断裂强度保持率高达80.2%，断裂伸长保持率达79.0%； - The structure of treated fiber is analyzed by DSC, DMA, X-diffraction and SEM. And some properties are tested such as contact angle, breaking tenacity and interfacial shear strength.
通过DSC、DMA、X-衍射和SEM分析纤维的结构，测试了纤维接触角、断裂强度和层间剪切强度。 - On the testing method for breaking tenacity and elongation of manmade filaments
化纤长丝断裂强力和断裂伸长测试方法的探讨 - Under the conditions of reducing the polyester viscosity, raising the production load, by improving the after-spinning stretching ratio and stretching temperature, the quality indexes such as breaking tenacity etc were guaran-teed. The fiber drawing performance was improved.
在降低聚酯黏度、提升负荷的条件下，通过提高后纺拉伸倍率，拉伸温度等来保证断裂强度等品质指标，改善了纤维的拉伸性能。 - Breaking strength ( tenacity) is positively correlated with breaking extension ( extensibility) and breaking work at 1% level.
纤维断裂强度强度与断裂伸长伸长率呈极显著正相关，与断裂功极显著正相关。 - PET industrial yarn not only has a good chemical stability as common yarns but also has excellent mechanical performance such as high breaking tenacity, high modulus, and good impact resistance.
涤纶工业丝不但具有普通涤纶良好的化学稳定性，还具有高强度，高模量，低延伸，耐冲击，耐疲劳，耐热性好等优良的物理机械性能。 - Breaking tenacity and elongation not only of hollow PP fibre but of hollow PP-g-MAH fibre is lower than that of the common sectional fibre.
与普通纤维相比，无论PP，还是PP唱一MAH，其中空纤维的相对断裂强度和断裂伸长都要低很多； - The study shows that the content of the ES fibers is the main factor to the products 'performance. With the increasing of the ES fibers, the breaking tenacity both longitudinal and crosswise are raised greatly.
经研究表明：ES纤维含量对产品的各项性能影响最大，ES纤维含量增大，样品的纵横向单位断裂强度增加显著。 - Y using the orthogonal optimal method in the quality engineering and in accordance with the signal-noise ratio, an optimal design of the spinning technological parameters of PP filament is suggested, which promote the breaking tenacity of the filament remarkably.
用质量工程学中的正交优化法，以信噪比为分析依据，对丙纶长丝的纺丝工艺参数进行优化设计，提高了纤维的断裂强度。 - The performance was the best to the dry-spinning with the complexation of 0.04 and the density of 22%. With the increasing of the spinning pressure, elastic modulus and breaking tenacity apparently improved. Good performance fibers could be obtained.
络合比0.04，浓度22%的PA6络合液最适合目前装置的干法纺丝，并且随着纺丝压力的增大，纤维的断裂强度和弹性模量都明显增大，可以明显提高纤维性能。